PLANNING

Power of Design

For Higher Generated Power Output

Based on our rich construction experience, we can design power plants which are optimal for areas with heavy snowfalls and even high temperatures and humidity.

Model for the areas with heavy snowfalls

Model for snowy areas
Model for snowy areas

The snow has a strong property of reflecting sunlight. We offer the “high elevation installation stand” for installations at angles steeper than usual, so that snow would hardly accumulate on the solar panels in areas with heavy snowfalls. The highly durable mount can be used in areas with heavy snowfalls with depths of snow reaching 180 cm.

Model for areas with high temperatures and humidity

Model for areas with high temperatures and humidity
Model for high-temperature and high-humidity area

[Wind resistance Strength up to 80 m/s]

We have successful results of installing solar panels in areas with salt-air damage such as by typhoons, heavy winds and high waves.
Based on such experience, we can offer a power plant project able to meet the requirements for strength such are stands with full covers mounted on them as a measure against strong winds and strong foundations tailored to the ground condition.

Photo on the left:
Full cover as a measure against strong winds


In addition to the back side, it is possible to install solar panels in regions with strong winds by covering the sides as well as the front part.

Overloaded model for common areas

General Area Overloaded Model
General Area Overloaded Model

It has become possible to increase the volume of power generation by expanding solar power modules at a power plant even after starting it operation.
Taking the effect of shadows into consideration, it is designed to seek the maximum level of power generation by expanding the modules towards open areas.
In case there is a need to connect modules with those on the existing stand, we will accomplish that with a custom order mount.